STIHL MS 880 R MAGNUM Manual de instrucciones descargar pdf (Pagina 44)

MS 880

English

42

Tensioning the rewind spring

N Make a loop in the unwound starter

rope and use it to turn the rope rotor

five full revolutions in the direction of

the arrow

N Hold the rope rotor tight: pull out the

twisted rope and untangle it

N Release the rope rotor

N Slowly let go of rope so that it winds

onto the rotor

The starter grip must be drawn firmly

into the rope guide bush. If it tips

sideways: increase the spring tension by

another turn.

N It must be possible to turn the rope

rotor on another half-turn when the

rope has been drawn out

completely. If not, the spring has

been tensioned too tightly and may

break. Remove one turn of the rope

from the rotor.

N Mount the fan housing on the

crankcase

N Move the Master Control lever to the

stop position 0

N Press the remaining rope into the

handle until the nippel (6) is flush

with the handle

Replacing broken rewind spring

N Remove the rope rotor as described

for "Replacing the starter rope".

N Remove parts of spring

N Apply a few drops of resin-free oil to

the new replacement spring – do not

open the wire loop (retainer)

N Insert the rewind spring – engage

outer spring loop over the lug – this

will simultaneously remove the wire

loop

N Reinstall the rope rotor, tension the

rewind spring, replace the fan

housing and screw it into place

If the spring has popped out: refit it –

working counterclockwise – from the

outside inwards

001BA006 K

The broken pieces of spring may

still be under tension and can

spring apart unexpectedly on

removal from the housing – risk

of injury! Wear a face shield and

protective gloves.

6

001BA104 ST

171BA021 KN

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 123 124

Comentarios a estos manuales

Sin comentarios