STIHL MS 181 C-BE Manual de instrucciones Pagina 45

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 140
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 44
MS 171, MS 181, MS 181 C, MS 211, MS 211 C
English
43
N Turn the guide bar over every time
you sharpen the chain and every
time you replace the chain – this
helps avoid one-sided wear,
especially at the nose and
underside of the bar.
N Regularly clean the oil inlet hole (1),
the oilway (2) and the bar groove
(3).
N Measure the groove depth with the
scale on the filing gauge (special
accessory) – in the area used most
for cutting.
If groove depth is less than specified:
N Replace the guide bar.
The drive link tangs will otherwise
scrape along the bottom of the groove
the cutters and tie straps will not ride on
the bar rails.
Removing the shroud
N Squeeze the throttle trigger and
move the Master Control lever to l
.
N Slide the lock to the rear.
N Remove the shroud upwards to the
rear.
Installing the shroud
N Refit the shroud and secure it with
the lock.
Taking Care of the Guide Bar
2
3
1
143BA026 KN
Chain
type
Chain pitch Minimum
groove depth
Picco 1/4" P 0.16" (4.0 mm)
Rapid 1/4" 0.16" (4.0 mm)
Picco 3/8" P 0.20" (5.0 mm)
Rapid 3/8"; 0.325" 0.24" (6.0 mm)
Rapid 0.404" 0.28" (7.0 mm)
Shroud
533BA002 KN
Vista de pagina 44
1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 139 140

Comentarios a estos manuales

Sin comentarios