STIHL MS 261 C-M Manual de instrucciones descargar pdf (Pagina 42)

MS 261 C-M

English

40

Removing the Shroud

N To switch off the engine, move the

Master Control lever in the direction

of STOP or † – when released, the

Master Control lever springs back to

the run position F.

N Push the hand guard forward – the

chain is locked.

N Open the twist locks (1) by turning

them 1/4 turn counterclockwise with

the combination wrench.

N Remove the shroud (2).

Installing the Shroud

N Place the shroud in position.

N Close the twist locks by turning

them a 1/4 turn clockwise.

If there is a noticeable loss of engine

power

N Remove the shroud – see "Shroud".

Removing the air filter

N Clean away loose dirt from around

the filter.

NOTICE

To avoid damaging the filter, do not use

tools for removing and installing the air

filter.

N Rotate the air filter a 1/4 turn

counterclockwise and lift it away in

the direction of the rear handle.

N Always replace damaged filters.

Cleaning the air filter

N Wash the filter in STIHL special

cleaner (special accessory) or a

clean, non-flammable solution (e.g.

warm soapy water). Rinse the filter

from the inside outwards under a jet

of water – do not use a pressure

washer.

N Dry the filter components – do not

expose to high temperatures.

N Do not impregnate the filter with oil.

N Reinstall the air filter.

Installing the air filter

N Place the air filter in position.

N Push the air filter in the direction of

the filter housing and turn it

clockwise at the same time until it

engages – the "STIHL" name must

be horizontal.

N Install the shroud – see "Shroud".

Shroud

1

1

1

001BA199 KN

2

Cleaning the Air Filter

1.

5902BA010 KN

2.

5902BA011 KN

2.

1.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 123 124

Comentarios a estos manuales

Sin comentarios