
MS 170, MS 170 C, MS 180, MS 180 C
English
53
Chain sprocket
To ensure compliance with the kickback
properties required in Section 5.11 of
ANSI B 175.1-2000, only use
replacement chains that, when used
with this specific powerhead, comply
with Section 5.11 of the ANSI standard
or are classed as "low kickback" chains
according to ANSI B 175.1-2000.
Please ask your STIHL dealer for the
latest recommendations on new
bar/chain combinations developed after
publication of this instruction manual.
Cutting Attachments for MS 180 C
Recommended cutting attachments
complying with Section 5.11 of ANSI B
175.1-2000.
Observe notes on ANSI B 175.1-2000
and definition of "low kickback chain" in
chapter on "Safety Precautions and
Working Techniques".
Rollomatic E guide bars
3/8" Picco chain
Chain sprocket
To ensure compliance with the kickback
properties required in Section 5.11 of
ANSI B 175.1-2000, only use
replacement chains that, when used
with this specific powerhead, comply
with Section 5.11 of the ANSI standard
or are classed as "low kickback" chains
according to ANSI B 175.1-2000.
Please ask your STIHL dealer for the
latest recommendations on new
bar/chain combinations developed after
publication of this instruction manual.
Contact your STIHL dealer for
information regarding special
accessories that may be available for
your product.
6--tooth for 3/8" (spur sprocket)
Reduced kickback STIHL guide bar
(with green label)
Cutting lengths: 12, 14, 16 in (30,
35, 40 cm)
Pitch: 3/8" P (9.32 mm)
Groove width: 0.050 in (1.3 mm)
Low kickback STIHL saw chain (with
green label)
Picco Micro 3 (63 PM3) Type 3636
Pitch: 3/8" P (9.32 mm)
Drive link gauge: 0.050 in (1.3 mm)
6--tooth for 3/8" (spur sprocket)
Special Accessories
Comentarios a estos manuales