
MS 461
English
34
At temperatures under +14 °F (-10 °C)
Under extreme winter conditions
(temperatures below 14 °F (--10 °C),
powdered or drifting snow), it is
recommended to mount the cover plate
(special accessory) on the fan housing.
The partial covering of the slits in the fan
housing keeps out powdered or drifting
snow.
In case of erratic idling behavior or poor
acceleration
N Turn the low speed screw (L)
1/4 turn counterclockwise
Whenever the low speed screw (L) has
been adjusted, it is usually also
necessary to adjust the idle speed
screw (LA), see "Setting the carburetor".
When the cover plate is mounted, the
slide must be in winter position in the
carburetor box cover.
N if the chain saw is extremely cold
(frost formation) – after starting,
bring the engine up to operating
temperature at increased idle speed
(disengage chain brake!)
N if engine trouble occurs, first check
whether use of intake air pre-
heating is necessary
Mounting the cover plate (special
accessory)
N Insert cover plate (1) with both tabs
(arrows) and snap it onto the fan
housing
N Screw in screws (2)
When the mounting kit is used, the
shutter must be in the winter position.
If engine trouble occurs, first check
whether use of the cover plate is
necessary.
Switching on the handle heating system
(depending on equipment version)
N Set switch to F – to switch off, return
switch to the 0 position
Overheating during continuous use is
impossible. The heating system is
maintenance-free.
Electric Handle Heating
Comentarios a estos manuales