STIHL MS 461 R Manual de instrucciones descargar pdf (Pagina 37)

MS 461

English

35

The four positions of the Master Control

lever:

Stop 0 – engine off – the ignition is

switched off

Normal run position (F) – engine runs or

can fire.

Warm start (n) – this position is used to

start a warm engine.

Cold start (l) – this position is used to

start a cold engine.

Setting the Master Control Lever

To move the Master Control lever from

the normal run position (F) to cold start

(n), press down the throttle lockout and

squeeze the throttle trigger at the same

time.

To select warm start (n), move the

Master Control lever to cold start (l)

first, then push it into the warm start

position (n).

The change to warm start (n) is only

possible from the cold start

position (l).

The Master Control lever moves from

warm start (n) to the normal run

position (F) when the throttle trigger is

operated.

To switch off the engine, move the

Master Control lever to Stop (0).

Choke shutter closed (l)

– if the engine is cold

– if the engine stalls when you open

the throttle after starting.

– if the fuel tank was run until empty

(engine stopped).

Starting throttle position (n)

– if the engine is warm, i.e. if it has

been running for about one minute.

– after engine begins to fire,

– after clearing a flooded combustion

chamber.

Holding the Saw

There are two ways of holding the saw

when starting.

On the ground

N Place your saw on the ground.

Make sure you have a firm footing –

check that the chain is not touching

any object or the ground.

N Hold the saw firmly on the ground

with your left hand on the front

handle – your thumb should be

under the handle.

N Put your right foot into the rear

handle or your right heel on the rear

hand guard and press down.

Starting / Stopping the

Engine

STOP

0

001BA140 KN

3443BA024 KN

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 127 128

Comentarios a estos manuales

Sin comentarios